Botvac D75 battery connector on the motherboard

News and information about the Neato XV-11 Robotic Vacuum. All discussion and troubleshooting questions go here.

Botvac D75 battery connector on the motherboard

Postby TechGuy » May 25th, 2018, 10:29 pm

I am working on a Botvac with battery connector pins became loose at the motherboard. These two pins are still at their respective holes on the motherboard. I can rotate them around. I soldered these pins to the motherboard. But this Botvac is still not power up.

I am just guessing. These pin may be connected to the middle layer copper foils. When these pins became loose and turning in the hole, the connections to the middle layer copper foils were broken.

Anyone has info. about the battery connector pins connected to which components. Circuit diagram showing the battery connector will be great. TIA
Charging battery directly: 400 Series, 500 Series,.H-Bridge Repair How to Desolder
Robot Addict
Posts: 1585
Joined: February 17th, 2009, 11:52 pm

Re: Botvac D75 battery connector on the motherboard

Postby shirgal » May 29th, 2018, 6:38 pm

The pins are soldered to upper layer of the board, not to the middle.
I have replaced them (all pins for the battery board)in complete with no problem.
User avatar
Robot Addict
Posts: 160
Joined: July 8th, 2013, 10:54 am

Return to Neato Robotics

Who is online

Users browsing this forum: BrettS, jdong, txenakis, vic7767 and 405 guests