vic7767 wrote:1610 is 4:10pm, and 1810 is 6:10pm.
Since you are set up to send commands, you can send the master reset command "7" to clear your schedule as well as all other timers and registers in the MCU.
benjaminchodroff wrote:I ran into problems on Windows 7 64 Bit with my instructions I posted earlier in this thread.
I fixed it by installing the iRobot drivers manually and installing mscomm32.ocx.
Get mscomm32.ocx here: http://www.ocxdump.com/download-ocx-fil ... nload.html
Register it by opening a command prompt in administrator mode, navigate to the ocx file and register it:
Then I went into device manager, found the device that was reporting a missing driver, pointed it at these drivers unzipped into a directory:
I then went into the device under ports in device manager and made sure it was set to the correct rate (115k)
Sorry for the lack of clarity (I didn't take detailed notes), but I hope this helps you. I got it working, don't give up hope! Oh, and I think I had to reboot Windows a few times (and for some reason install multiple drivers...). Good luck.
Users browsing this forum: bjarnewarming and 149 guests